The earliest four screw guns (top sideplate screw not present following a design change) are not model-marked guns and are few in number, because they were made for only a few months before the Model-stamping began. The model marking is found on the frame under the yoke.Ī couple of quick indicators: Any five screw guns (easily identified by the presence of a sideplate screw at the top of the plate near the hammer) are NOT model-marked guns. Some non-model marked guns may be found with higher numbers, and lower numbers may be found on guns that are model marked.
#Toon boom studio 8 crack serial number
Model marked guns were introduced around serial number K325000, but that is not a crisp dividing line.
#Toon boom studio 8 crack serial numbers
The K-prefix in serial numbers identifies the adjustable sight K-frames of whatever caliber, so K-22s and K-38s of any barrel length, as well as the rare K-32s are all numbered together. In 1957 the company introduced model number designations and the K-22 Masterpiece became more commonly referred to as the Model 17. The K-22 was manufactured continuously under the Masterpiece designation thereafter. Serial numbers are in the high 600,000 range.Īfter WW2, the company reintroduced the K-22 Masterpiece with some design changes and a new serial number sequence beginning at K101 in late 1946 or early 1947. It was manufactured for only a year before the company suspended commercial production and converted to production under military contracts. In 1940 they introduced the K-22 Masterpiece (K-22 Second Model, or K-22/40), which had a shorter action and an improved adjustable rear sight. These are not Masterpieces in the marketing sense, but they are the direct precursor of the K-22s that got the Masterpiece designation. They are easily identified by their prewar hammers and the lack of a barrel rib. 22, the K-22 Outdoorsman (or K-22 First Model), in in 1931.
I regularly compete with the 617 in Steel Challenge.
If you have been following Revolvers Only you may remember my post on the Smith & Wesson 617. Smith & Wesson has even introduced a stainless steel target gun, the 617, with a ten shot cylinder and bull barrel. Later versions of this revolver are known as the Model 17. This wheel gun is a joy to shoot, even if it only visits the range a couple times each year. The double action is a bit heavy, but I believe most shooters fired this revolver in single action. The bluing is beautiful and the single action trigger is better than any of my 'modern' Smith and Wesson revolvers. The craftsmanship of older S&W revolvers is impressive. I have a hard time seeing all black sights, but even I can keep them in the ten ring at 10 yards. 22 handgun, but the six inch barrel aids in accuracy. To my knowledge, this revolver was designed and produced with similar handling characteristics of the K38 Masterpiece chambered in. This particular revolver is a Smith & Wesson K22 Masterpiece, which was manufactured right before the introduction of model numbers. As a ten year old who had only fired BB guns up to this point, this was an awesome opportunity! I remember shooting at an empty can. Prior to my interest in revolvers, I only fired this revolver one time on a vacation to the farm. This was before I started writing, but I took some great pictures of it at the range! You can see the wear marks on the barrel, cylinder, and a small chip on the stocks. This revolver was actually with me in Texas when I got the news.
0 kommentar(er)
